Step 5: Flight controller
The ROBAN X2 in the kit is a QioTek Adept F407 running ArduCopter Heli. It does the stabilisation, GPS hold and return to home, so you only change a handful of parameters.
Connect
Section titled “Connect”Use Mission Planner or APM Planner over USB. The USB-C port on the X2 needs a USB-A host. A plain USB-C to USB-C cable into a laptop won’t show up at all. Go through a USB-A port or adapter, with a cable that carries data.
If Mission Planner offers a firmware update, decline it.
Parameters
Section titled “Parameters”In Mission Planner press Connect, open Config, then Full Parameter List. Find each name, type the value, press Write Params.
| Parameter | Value | What it does |
|---|---|---|
SERVO9_FUNCTION | 60 | Output 9 follows channel 10, gimbal yaw |
SERVO10_FUNCTION | 61 | Output 10 follows channel 11, gimbal pitch |
That’s all the gimbal needs. SERVO_RATE stays at 50 Hz. Direction: 1100 µs is yaw left and pitch down.
These suit a HOTAS, and they’re optional:
| Parameter | Factory | Ours | Why |
|---|---|---|---|
RC1_DZ to RC4_DZ | 20, 20, 10, 15 | 5 | A precise HOTAS doesn’t need a wide deadband |
ARMING_RUDDER | 2 | 1 | Rudder arms only. With 2, collective down and full left pedal for 2 seconds also disarms in flight in Angle and Manual |
PILOT_SPEED_UP | 250 | 150 | Gentler climb in GPS mode, in cm/s |
PILOT_SPEED_DN | 0 | 100 | 0 means “use the climb speed”, so 2.5 m/s towards the ground |
Low-battery return to home
Section titled “Low-battery return to home”| Parameter | Ours | Notes |
|---|---|---|
BATT_LOW_VOLT | 12.4 | 3.1 V per cell, for our Li-ion packs |
BATT_LOW_TIMER | 8 | Seconds below the threshold |
BATT_FS_LOW_ACT | 2 | Return to home |
BATT_CRT_VOLT, BATT_FS_CRT_ACT | 0 | Critical failsafe off, our choice: no automatic landing away from home |
Check every channel
Section titled “Check every channel”In Mission Planner, under Setup, Mandatory Hardware, open Radio Calibration and watch the bars only. Don’t press Calibrate, it overwrites the factory calibration. Move each control and compare it with the channel plan. Move your head and watch channels 10 and 11.
If one channel comes out reversed, check all four stick axes before you trust any of them, and fix it in Magic Box.
Test the gimbal
Section titled “Test the gimbal”In GimbalConfig, check that the gimbal’s default mode (preset M0) is FPVM-ANGL, then press Save To Flash. With the mode wire left unconnected, as here, the gimbal always uses this preset, and the factory setting can differ. Plug in the FPV power and move your head. If the gimbal ignores you:
- Check the common ground: 0 V.
- Put a multimeter on DC volts on the signal pin. 1500 µs reads about 0.25 V and changes as you move your head.
- Tilt the base by hand. If the camera follows smoothly, FPV mode is active.
Gimbal modes and calibration are on FPV Gimbal (XF C-20T). The X2 has no onboard log storage, so bring a laptop to the field if you need to see what it sees.